Overhaul centrifugal pump bearing thrust bearing

Web Design And Seo For www.china-webdesign.com

machine bearing - China Manufacturer

Thank you for inquiry my machine bearing, Tel : 0086-0379-64390888, E-mail: liuping@lyzyc.cc

http://www.lyzycbearing.com/key-machine-bearing-24/

Wear, deformation, cracks, scratches, delamination, crush and burn defects; â'  bush should be no contact with the thrust plate at the prints should be uniform, the contact area should be not less than 70 and the entire circumference of each tile are clot h; same group pad thickness difference is not greater than 0.01mm, tile the babbitt direction of rotation should be rounding into the oil wedge back bearing surface Lee lubricating oil to enter; smooth.screw bearings
â'¡ adjustment shims should be smooth, flat, not to deflect the difference with a thickness greater than 0.01mm layer gasket.
â'¢ bearing cap assembled push shaft repeatedly measuring the thrust bearing clearance, its value should be within the requirements. A thrust bearing gap is measured by this method and use of the side of the shaft displacement probe must be consistent, in accordance with the provisions of adjusting the displacement of the probe indicates zero bit.
The â'£ bearing shells levels combined face tight, a good bit. The measured oil temperature hole vagay eye alignment, not skewed. The hole is clean and smooth.slim bearings< /a>