What are the bearing oil lubrication methods include

Web Design And Seo For www.china-webdesign.com

china ball bearing - China Manufacturer

Thank you for inquiry my china ball bearing, Tel: 0379-64331653, E-mail: info@lyvsg.com

http://www.lyvsg.com/key-ball-bearing-company-10/

a oil bath lubrication

Oil bath lubrication is the most common method of lubrication, for low, medium speed bearing lubrication, the bearing part is immersed in by the groove, the lubricating oil by the rotation of the bearing parts brought u p, and then to flow back to the sump oil should be slightly lower than the lowest the center of the rolling bodies. bearing suppliers

b lubrication.

The drip lubrication is suitable for quantitative supply lubricating oil was bearing components, drip volume generally every 3-8 seconds a drop is appropriate, too much oil will cause increased bearing temperature.

c circulating oil lubrication

With a pump the filtered oil is supplied to the bearing member, filtered again after cooling through the bearing lubricating oil. Bearing cooling cycle oil can be taken away a certain amount of heat, and therefore the method is suitable for high speed bearing components.

d spray lubrication

Formed by mixing with dry compressed air through the sprayer with the lubricating oil mist, ejection bearing, airflow can be effectively cool the bearing and preventin g intrusion. This method is suitable for high-speed, high-temperature lubrication of the bearing components. thrust roller bearing

e jet lubrication

With a pump to the high pressure oil through the nozzle incident bearing, incident on the oil in the bearings in the other end via a bearing into the oil sump. Bearing rotates at high speed, the rolling body and the retainer so that the surrounding air with a relatively high rotational speed to form a gas stream, with the general method of lubrication is difficult in the lubricating oil to the bearings must be used high-pressure injection method, then the lubricating oil spray to the bearing, the position of the nozzle should be placed on the inner ring and between the holder center.